brandon9271 (November 30, 1999 at 12:00 am)

I'd like to know this myself! It seems most guitar makers use RhinoCam or MasterCam

jeetendrag10 (November 30, 1999 at 12:00 am)

hi haydn, where do you get those supported linear bearings in uk/ireland?how much do they cost? my relatives are in uk and ireland,i could get them to ship it to me if i get some ifo where to get them

haydn812 (November 30, 1999 at 12:00 am)

No problem with yaw (or crabbing), it depends on the spacing of the x axis carriages. Two screws can cause twice as many problems as one, not many commercial machines use two screws. If your building a plasma then you certainly wont need two screws as the load on the gantry is minimal.

davi200 (November 30, 1999 at 12:00 am)

I see that you are driving the gantry in the X axis with a single ballscrew shaft mounted in the center underneath the table. Is there any problem with yaw (clockwise/counterclockwise rotation as viewed from above) of the gantry with that setup? Do you think it would have been better to drive it with a ball screw on each long side of the bed? Planning my own CNC plasma machine, so that's why I ask. Great vid by the way!

haydn812 (November 30, 1999 at 12:00 am)

£2000 to build approx

Baraquiel62 (November 30, 1999 at 12:00 am)

How much would cust this machine?

CipollaErMeyo (November 30, 1999 at 12:00 am)

wow PRS style body!!!

woodworky (November 30, 1999 at 12:00 am)

Very good work. I have a CNC made out of wood and would like to make improvements to stiffen the structure. Is it possible to have all the structural drawings to build one like yours? I would greatly appreciate. Thanks,

bodthemod69 (November 30, 1999 at 12:00 am)

the way your post go,s with the music is amazing you should send this to the chemical brothers you could be the first CNC video artist.

SimonVThomsen (November 30, 1999 at 12:00 am)

can i get the cad droning ?